Makita CE001G Instruction Manual page 12

Cutting
CAUTION:
During operation, do not bring the
tool higher than your shoulder height.
Fig.14
Hold the tool firmly. Grasp the handle with your right
hand and the front grip with your left hand. To prevent
electric shock by accidental cutting of an electric cable,
always hold the front grip by the designated portion as
shown in the figure.
Fig.15
► 1 . Part to hold
Move the tool over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance uniform.
Fig.16
NOTE: When the battery cartridge temperature is
low, the tool may not work to its full capacity. At this
time, for example, use the tool for a light-duty cut for
a while until the battery cartridge warms up as high
as room temperature. Then, the tool can work to its
full capacity.
NOTE: If the cutting action of the diamond wheel
begins to diminish, dress the cutting edge of the
wheel using an old discarded coarse grit bench
grinder wheel or concrete block. Dress by pressing
lightly on the outer edge of the diamond wheel.
When feeding water during cutting
CAUTION:
wheel, always feed water during cutting.
Connect the tool to the water supply and turn the cock
in the direction of the arrow as illustrated. Adjust the
position of the cock to obtain a gentle flow of water.
1
Fig.17
► 1 . Cock
12 ENGLISH
When using a wet-type diamond
1