Self-Diagnosis Display - Sony CMT-M333NT Operating Instructions Manual

If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
1
Disconnect the mains lead.
2
Reconnect the mains lead.
3
Press ?/1 on the unit to turn on the system.
4
Press x, ENTER/START and ?/1 on the
unit at the same time.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.

Self-diagnosis display

This system has a Self-diagnosis display
function to let you know if there is a system
malfunction. The display shows a code made up
of three or five letters and a message alternately
to show you the problem. To solve the problem
refer to the following list. If any problem
persists, consult your nearest Sony dealer.
C11/Protected
The MD is protected against erasure.
cRemove the MD and slide the tab to close the slot
(page 15).
C12/Cannot Copy
You tried to record a CD with a format that the
system does not support, such as a CD-ROM.
cRemove the disc and turn off the system once,
then turn it on again.
C13/REC Error
Recording could not be performed properly.
cMove the system to a stable place, and start
recording over from the beginning.
The MD is dirty or scratched, or the MD does not
meet the standards.
cReplace the MD and start recording over from the
beginning.
C13/Read Error
The MD deck cannot read the disc information
properly.
cRemove the MD once, then insert it again.
C14/TOC Error
The MD deck cannot read the disc information
properly.
cReplace the MD.
cErase all the recorded contents of the MD using
the All Erase Function (page 29).
continued
GB
57