Erasing A Disc Title - Sony CMT-M333NT Operating Instructions Manual

6
Press ENTER/YES to complete the
labeling procedure.
To change the character
In step 3 or 4, press TCURSOR or
CURSORt repeatedly until the character to be
changed flashes, press CLEAR to erase the
character, then repeat steps 3 and 4.
To add a character
After steps 1 and 2, press TCURSOR or
CURSORt until the cursor comes to the point
you want to add a character, then proceed to step
3.
To cancel labeling
Press MENU/NO.
Checking the disc titles
1
Press FUNCTION repeatedly to switch
the function to CD.
2
Press MENU/NO in stop mode.
3
Press . or > repeatedly until
"Name Check?" appears, then press
ENTER/YES.
4
Press . or > repeatedly to select
the disc titles stored in the system
memory between 01 and 50.
To check the current disc title
Press SCROLL in stop mode.
GB
10

Erasing a disc title

1
Press FUNCTION repeatedly to switch
the function to CD.
2
Press MENU/NO in stop mode.
3
Press . or > repeatedly until
"Name Erase?" appears, then press
ENTER/YES.
4
Press . or > repeatedly to select
the disc title you want to erase.
"No Name" appears if no disc title is
labeled.
5
Press ENTER/YES again.
"Complete!" appears.
To erase all disc titles
Press . or > repeatedly until "All Erase?"
appears in step 3, then press ENTER/YES twice.
To cancel erasing
Press MENU/NO on the remote during step 2
through 4.
Note
The disc titles are saved in the system memory for
about a day even if you disconnect the mains lead or a
power failure occurs.