Sony CMT-M333NT Operating Instructions Manual page 35

7
While monitoring the sound, press .
or > repeatedly to change the
recorded level.
The recording level can be changed from
–12 dB to +12 dB, in 2 dB steps. Change to
the optimum level while making sure that
"OVER" does not appear in the display at
the loudest portion.
Adjust the level so as not to light up "OVER".
8
Press ENTER/YES.
"S.F Edit OK?" appears.
9
Press ENTER/YES again.
The system starts recording over the
existing track.
"S.F Edit: ** %" appears while the track is
being recorded. An amount of time that is
roughly equal to or longer than the playback
time of the track is required when recording
over the track. When the recording finishes,
"Complete!" appears.
Fade-in and Fade-out
Recording
1
Press FUNCTION repeatedly to switch
the function to MD.
2
Press PLAY MODE in stop mode
repeatedly until both "PGM" and
"SHUF" disappear.
3
Press MENU/NO.
4
Press . or > repeatedly until "S.F
Edit?" appears, then press ENTER/
YES.
5
Press . or > repeatedly until
"Fade In?" or "Fade Out?" appears,
then press ENTER/YES.
Playback starts.
6
Press . or > repeatedly until the
track number you want to change the
recording level appears, then press
ENTER/YES.
"Time5.0s" appears.
7
While monitoring the sound, press .
or > repeatedly to change the Fade-
in or Fade-out recording time.
The system plays the portion that will be
recorded over using Fade-in or Fade-out
Recording. You can set the time at any
TOC
value between 1.0 second and 15.0 seconds,
in 0.1 second steps. You cannot set the time
OVER
longer than the track.
8
Press ENTER/YES.
"S.F Edit OK?" appears.
9
Press ENTER/YES again.
The system starts recording over the
existing track.
"S.F Edit: ** %" appears while the track is
being recorded. When the recording
finishes, "Complete!" appears.
To cancel the operation
Press MENU/NO during step 4 through 8. After
pressing ENTER/YES in step 9 to start
recording, you cannot interrupt the operation.
Notes
• Do not disconnect the mains lead or move the system
while recording is in progress. This may damage the
recording data preventing recording from being
performed properly.
• You cannot change the recording level of the tracks
recorded in MDLP mode.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo the S.F Edit Function even if you
use the Undo Function.
GB
35