Honeywell NOTIFIER LCD6000T Programming And Installation Manual page 25

Tracking option
TEC2 Programming:
First folder or Main folder (Progr. of Type ID and reading associated with the sensor)
P = programmed sensor
Sensor address
Press the key
F1 to program a sensor
of the previous line
Press the key
F2 to program a sensor
of the subsequent line
LCD6000
LCD6000_manu-inst
By selecting "NO" in the function "Led Blink" the flashing
of the led on the module during the line query is disabled.
This function can be useful in such environment as
hospitals, hotels, etc.
Press the key F3 to program
the previous sensor
Press the key F4
to program
subsequent sensor
Installation manual
Doc. M-184.1-LCD6000T-ENG Rev A.2
Range = Configuration of highest value of the
scale (refer to Technological Range table)
Attention: do not change the default
datum of the relative sensitivity
Threshold sending = Configuration of the
operation feature
(refer to previous paragraph).
Pre-alarm 1 threshold Programming
The default value is 10% of the selected
highest value of the scale
The Pre-alarm 2 threshold Programming
The default value is 20% of the selected
highest values of the scale
The alarm threshold Programming
The default value is 0% of the selected
highest value of the scale.
Type ID
Programmable reading max.32 characters
the
NOTIFIER ITALIA
PAGE - 23