ENGLISH (Original instructions) SPECIFICATIONS Model TD126D TD127D Machine screw 4 mm - 8 mm Capacities Standard bolt 5 mm - 14 mm High tensile bolt 5 mm - 12 mm No load speed (min 0 - 2,400 0 - 2,300...
Page 3
If operating a power tool in a damp location is 20. Store idle power tools out of the reach of unavoidable, use a ground fault circuit children and do not allow persons unfamiliar interrupter (GFCI) protected supply. Use of an with the power tool or these instructions to GFCI reduces the risk of electric shock.
Page 4
GEB054-1 breakdown. Do not store the tool and battery cartridge in CORDLESS IMPACT DRIVER locations where the temperature may reach or SAFETY WARNINGS exceed 50 C (122 F). Do not incinerate the battery cartridge even if it Hold power tool insulated gripping is severely damaged or is completely worn out.
Overloaded: • FUNCTIONAL DESCRIPTION The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, release the switch trigger on CAUTION: the tool and stop the application that caused Always be sure that the tool is switched off and the •...
Page 6
For tool with shallow bit hole NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. • Be careful not to scratch the lens of lamp, or it may Use only these type of bit. Follow the A=12mm lower the illumination.
NOTE: If the bit is not inserted deep enough into the Standard bolt • (kgf.cm) sleeve, the sleeve will not return to its original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above.
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Screw bits • Socket bits • Plastic carrying case •...