Ignition / Key Switch; Awd / 2Wd Switch (No Turf Mode) - Polaris RZR XP 1000 2017 Service Manual

Table of Contents

IGNITION / KEY SWITCH

1. Disconnect the key switch harness by depressing the

connector lock and pulling on the connector. Do not

pull on the wiring.

2. Test between the 4 sets of outputs (OFF / ACCY / ON

/ START). If any of the tests fail, replace ignition

switch assembly.

• In the OFF position, there should be no continuity

between any of the pins.

• Turn the key to ACCY position. There should be

contunity between switch pins A and B.

• Turn the key to ON position. There should be

continuity between switch pins A, B and D.

• Turn the key to START position. There should be

continuity between all the pins on the switch.

9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual

1. Disconnect the AWD / 2WD switch harness by

depressing the connector locks and pulling on the

connector. Do not pull on the wiring.

2. Test between the 2 sets of outputs (AWD / 2WD). If

any of the tests fail, replace the switch assembly.

• Move the switch to AWD (ON). There should be

continuity between switch pins 2 and 3 as well as 3

• Move the switch to 2WD (NONE / OFF). There should

ONLY be continuity between pins 3 and 7.