Rear Drive Shaft Installation - Polaris RZR XP 1000 2017 Service Manual

Table of Contents

12. Lower the trailing arm.

13. With a short, sharp jerk, remove drive shaft from the

transmission splines.

REAR DRIVE SHAFT INSTALLATION

1. Install new spring ring

anti-seize compound to the splines

on drive shaft. Apply an

2. Align splines of drive shaft with transmission splines

and reinstall the drive shaft. Use a rubber mallet to

tap on the outboard end of the drive shaft if

3. Swing the rear trailing arm assembly outward and

upward until the rear axle can be inserted into the

bearing carrier. Support the trailing arm from

4. Install the lower shock mounting bolt and new nut.

Torque fastener to specification.

Lower Shock Bolt to Trailing Arm:

70 ft-lbs (95 Nm)

5. Install the stabilizer bar mounting bolt, washer and

new nut. Torque fastener to specification.

Stabilizer Bar Linkage:

40 ft-lbs (54 Nm)

6. Apply Anti-Seize to drive shaft axle splines.

9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual