Table of Contents
Advertisement
Preparing the Remote Controllers
Load the two provided AAA-size batteries into the remote controller (YT-200).
To load batteries: Open the battery cover on the back of a remote controller. Load the batteries making
sure their poles (+/–) are facing in the correct directions. Finally, replace the battery cover.
Important!
Important!
Important!
To avoid running down the battery, store the remote control unit so its keys are not pressed
inadvertently.
When batteries go dead, remove them as soon as possible and replace them with two new
AAA-size alkaline batteries.
Configuring the Initial Settings of the Projector(s) Connected
to the Control Box
Perform the procedure below after locating the devices where they will be used, after connecting
cables, and after preparing the remote controllers.
If you have two projectors connected to the Control Box, you will need to perform the procedure
below on both of them.
Perform the operations below using the projector remote controller. Note that these operations
cannot be performed using the Control Box remote controller (YT-200).
To configuring the initial settings of the projector(s)
1.
Remove the Projector lens cover.
2.
Turn on Projector.
3.
After projection starts, perform the required operation on the projector to focus the
projected image.
For information about how to focus, see the User's Guide that comes with the projector.
4.
On the "Language" screen that appears, select the display language you want to
use.
5.
On the remote controller, press the [INPUT] key. On the "Input" dialog box that
appears, select "HDMI" and then press the [ENTER] key.
E-13
Getting Ready
Advertisement
Table of Contents
