Shaping Type: Cylinder 1 Or Cylinder 2 - Casio Touchboards YA-S10 Setup Manual

Shaping Type: Cylinder 1 or Cylinder 2

These shaping types are best for correcting for distortion that occurs when projecting onto cylindrical
columns and other curved surfaces. Use "Cylinder 1" for vertical cylinders and "Cylinder 2" for horizontal
cylinders.
To perform correction using "Shaping Type: Cylinder 1" or "Shaping Type:
Cylinder 2"
1.
Press the [CORRECT] key to display the Image Shaping menu.
2.
Select "Shaping Type" and then press the [ENTER] key.
3.
In accordance with the target screen shape, select "Cylinder 1" or "Cylinder 2" and
then press the [ENTER] key.
If there are previous corrections made with a different shaping type, a dialog box with the
message "All image shaping will be cleared. Do you want to continue?" will appear. Select "Yes",
and then press [ENTER].
4.
Use the "Image Shaping" menu to select one of the following shaping types in
accordance with the target screen to be projected upon: "Corner Correction",
"Base And Side Adjustment", "Side Correction (Arch)", "Center Point Correction".
For details about what you can do with each menu item, see "Performing Detailed Correction"
(page E-27).
5.
If required, adjust the aspect ratio of the projected image.
For details, see "Adjusting the Aspect Ratio of the Projected Image" (page E-30).
6.
After image shaping work is complete, display the "Image Shaping" menu and then
press the [ESC] key.
This will cause the image from the input source to be projected.
Using Shaping Functions
E-25