Table of Contents
Advertisement
Getting Ready
Wiring
The terminals on the sides and back of the Control Box connect to the power source and various devices
as described below.
Control Box Side: Connect one or two projectors.
When connecting the Control Box to a projector using a supplied HDMI cable, connect the plug of the
cable that is nearest the ferrite core to the HDMI port of the Control Box.
OUTPUT A Group
Ferrite core
Important!
Important!
Important!
If you are connecting only a single projector, use the OUTPUT A group terminals.
If you are connecting two projectors, the projector connected to the OUTPUT A group terminals
is referred to as "Projector A", while the projector connected to the OUTPUT B group terminals
is referred to as "Projector B". Later when configuring settings and making adjustments, we will
need to distinguish between Projector A and Projector B.
Control Box Back: Connect the AC adapter and the input source device.
*1
*1 To control the Projector System from an external device over a LAN, use a commercially available
LAN cable to connect this terminal to the LAN terminal of the external device.
*2 To control the Projector System from an external device over an RS-232C connection, use a
commercially available serial cable (cross) to connect this port to the serial port of the external
device.
OUTPUT B Group
Connect to the HDMI port of the second projector.
Connect to the RS-232C port of the second projector.
Connect to the HDMI port of the first projector.
Connect to the RS-232C port of the first projector.
Use a commercially available HDMI cable to connect to the HDMI output port of an image
source device.
*2
Use a commercially available cable to connect to the RGB output terminal or to
the component output terminal of an image source device.
Connect the supplied AC adapter and plug it into a power outlet.
E-12
Use a commercially available
RS-232C cable to connect.
Use a supplied HDMI cable to
connect.
Advertisement
Table of Contents
