Makita RP1802 Instruction Manual page 12

2. Connect a vacuum cleaner to the dust nozzle.
Fig.28
How to use screw M6 x 135 for
adjusting the depth of cut
When using the tool with a router table available in the
market, using this screw allows an operator to obtain
a small amount of adjustment of the depth of cut from
above the table.
Fig.29
► 1. Flat washer 6 2. Screw M6 x 135
Installing the screw and washer on
the tool
1.
Attach the flat washer onto the screw.
2.
Insert the screw through a screw hole on the tool
base and then screw in the threaded part of the motor
bracket of the tool. At this time, apply some grease or
lubricating oil to the inside of the screw hole on the tool
base and the threaded part of the motor bracket.
1
Fig.30
► 1. Flat washer 6 2. Screw M6 x 135
1
2
2
Fig.31
► 1. Screw M6 x 135 in a screw hole
1
Fig.32
► 1. Screw M6 x 135 2. Threaded part of the motor
bracket
Adjusting the depth of cut
1. A small amount of depth of cut can be obtained
by turning this screw with a screwdriver from above the
table. (1.0 mm per a full turn)
2.
Turning the screw clockwise makes the depth
of cut greater and turning the screw counterclockwise
makes the depth of cut smaller.
1
Fig.33
► 1. Screwdriver
12 ENGLISH
1
2