Makita PDC1200 Instruction Manual page 9

CAUTION:
Make sure that the battery is
securely fixed to the base plate. Otherwise, the
battery may fall when you wear the unit or use the
unit, and cause an injury. If you can see the red indi-
cator as shown in the figure, the battery is not locked
completely.
Fig.8
► 1. Red indicator
CAUTION:
Be careful not to pinch your fin-
gers or thumbs between the battery and the base
plate when attaching the battery.
CAUTION:
When removing the battery, press
the lock button while holding the handle firmly.
Before removing the battery, set the waist belt to
the lowest position.
1
Fig.9
► 1. Handle 2. Lock button
2. Adjust the position of the waist belt. Pull up the
height adjustment lever, then adjust the position of the
waist belt by sliding the base plate, and then return the
lever.
1
Fig.10
► 1. Height adjustment lever 2. Base plate 3. Waist
belt
CAUTION:
waist belt, be sure to lay down the unit so that the
battery faces downward as shown in the figure.
NOTICE:
If the height adjustment lever is loose,
tighten the nut of the height adjustment lever.
When tightening the nut, do not tighten it excessively.
Otherwise, the height adjustment lever will not move.
1
Fig.11
► 1. Nut
2
NOTE: If it is difficult to slide the base plate, lift up the
bottom of battery slightly so that the stand does not
touch the ground, and then slide the base plate.
Fig.12
9 ENGLISH
1
When adjusting the position of the
2 3