Grizzly G0602Z Owner's Manual page 41

8.
Use calipers to measure both ends of the
workpiece.
— If the test stock is thicker at the tailstock
end, move the tailstock toward the front of
the lathe ⁄ the distance of the amount of
1
2
taper (see Figure 40).
Move the tailstock toward
the front of the machine half
the distance of the taper
Looking down from above
Figure 40. Adjust tailstock toward the operator.
Model G0602/G0752 (Mfd. Since 03/17)
— If the test stock is thinner at the tailstock
end, move the tailstock toward the back of
the lathe ⁄ the distance of the amount of
1
2
taper (see Figure 41).
Looking down from above
Move tailstock toward the
back of the machine half
the distance of the taper
Figure 41. Adjust tailstock away from the
operator.
9. Repeat Steps 6–8 until the desired accuracy
is achieved.
-35-