Panel Explanation; For Vigorpro 5500 - Draytek VigorPro 5500 Quick Start Manual

1 . 1 P a n e l E x p
1 . 1 P a n e l E x p
1 . 1 . 1 F o r V i g
1 . 1 . 1 F o r V i g
LED
ACT (Activity)
Virus
IDP (Intrusion Detection and
Prevention)
DMZ
Monitor
VPN
QoS
LED on Connector
WAN
LAN/Monitor
LAN
Interface
RST
(Factory Reset)
WAN(1/2)
LAN/Monitor
LAN (1-4)
2
l a n a t i o n
l a n a t i o n
o r P r o 5 5 0 0
o r P r o 5 5 0 0
Status
Blinking
Off
On
(Yellow)
On
(Yellow)
On
On
On
Off
On
10 On
(left LED)
Off
Blinking
100 On
(right LED)
Off
Blinking
100 On
(left LED)
Off
Blinking
1000 On
(right LED)
Off
Blinking
Description
Restore the default settings.
Usage: Turn on the router (ACT LED is blinking). Press the hole and keep for
more than 5 seconds. When you see the ACT LED begins to blink rapidly than
usual, release the button. Then the router will restart with the factory default
configuration.
Connecter for remote networked devices.
Connecter for local networked devices.
Connecter for local networked devices.
Connecter for a power cord with 100-240VAC (inlet).
Power Switch. "1" is ON; "0" is OFF.
Explanation
The router is powered on and running normally.
The router is powered off.
The anti-virus function is enabled.
The anti-intrusion function is enabled.
DMZ Host is specified in certain site.
LAN traffic monitor is active.
The VPN tunnel is launched.
The VPN tunnel is closed.
The QoS function is active.
The port is connected with 10Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 100Mbps.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is disconnected.
The data is transmitting.
VigorPro 5500 Quick Start Guide