Makita DUA301 Instruction Manual page 12

4. Tighten 3 bolts using the hex wrench.
► 1 . Bolt
5. Loosen 2 bolts, and then remove 1 bolt.
► 1 . Bolt
6.
Loosen the lock ring by turning the lock ring coun-
terclockwise, then extend the pipe approximately 10 cm
or more, and then tighten the lock ring by turning the
lock ring clockwise.
1
3
► 1 . Lock ring 2. 10 cm or more 3. Pipe
1
1
2
7. Insert the pipe into the head of the tool all the way,
and then align the hole on the pipe with the hole on the
head of the tool.
► 1 . Hole 2. Pipe
8. Tighten 2 bolts using the hex wrench.
1
► 1 . Bolt
Removing or installing saw chain
CAUTION:
The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
CAUTION:
Carry out the procedure of install-
ing or removing saw chain in a clean place free
from sawdust and the like.
12 ENGLISH
1
2