Installing Hook - Makita DF0300 Instruction Manual

Adjusting the fastening torque
► 1 . Adjusting ring 2. Graduation 3.
The fastening torque can be adjusted in 21 levels by turning the adjusting ring. Align the graduations with the arrow
on the tool body. You can get the minimum fastening torque at 1 and maximum torque at
The clutch will slip at various torque levels when set at the number 1 to 20. The clutch does not work at
the marking.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
torque level is required for a particular application.
The following shows the rough guide of the relationship between the screw size and graduation.
Graduation
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Installing or removing driver bit/
drill bit
CAUTION:
After inserting the driver bit/drill bit,
make sure that it is firmly secured. If it comes out, do
not use it.
2
1
► 1 . Tighten 2. Sleeve 3. Ring
marking 4. Arrow
1 2 3 4 5 6
M4
–
–
3
1
2
3
4
7 8 9 10 11
M5
ɸ3.5 x 22 ɸ4.1 x 38
ɸ3.5 x 22
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the driver bit/drill bit in the
chuck as far as it will go. Hold the ring firmly and turn
the sleeve clockwise to tighten the chuck.
To remove the driver bit/drill bit, hold the ring and turn
the sleeve counterclockwise.

Installing hook

Optional accessory
CAUTION:
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
3
► 1 . Groove 2. Hook 3. Screw
6 ENGLISH
marking.
12 13 14 15 16 17
M6
ɸ4.1 x 38
When installing the hook, always
1
2
18 19 20
–
–
3