Table of Contents
Advertisement
FFT-24 Installation
2.
Attach strain relief clip to the phone cord. The strain relief clip should have about 2 ¾" of phone cord though it. See
Figure 3.6.
3.
Push the strain into the hole in the dead front panel.
3.3 FFT-24 Installation
The FFT-24 expander board lets you add additional zones to the -FFT.
To install the FFT-24:
1.
Open Cabinet door and dead front panel.
2.
Remove power. See Appendix A: for compatible powering devices.
3.
Remove blank plate and discard.
4.
Mount the FFT-24 on the six mounting studs located on the inside of the dead front panel and secure using the nuts
removed from the blank plate. See Figure 3.7.
Model SK-FFT Manual — P/N 54711:B2 12/18/2020
Figure 3.6 Installing Strain Relief Clip
mounting studs
Figure 3.7 Mounting Locations for the FFT-24
mounting studs
Installation
15
Advertisement
Table of Contents
