Makita MU02 Instruction Manual page 8

► 1. Blade cover 2. Shear blades
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
► 1. Basic alignment line on the tool housing 2. Pins
Adjust the three pin position so that these pins are lined
up at right angle in relation to the basic alignment line
on the tool housing.
4
► 1. Recessed part of crank 2. Crank 3. Apply grease
4. Pins
Fit the crank with its recessed part facing upwards onto
the pins. At this time, apply a small amount of grease to
the periphery of the crank using grease that the shear
blades as optional accessory are provided with or that
remains inside gear housing.
1
2
1
2
3
2
► 1. Base plate 2. Hole in the base plate of shear
blades 3. Oval holes that are overlapped
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
Turn the shear blades upside down and install it so that
the pins on the tool fit in the hole in the shear blades.
Make sure that the shear blades are set in place
securely as far as they reach the base plate.
1
► 1. Undercover 2. Locking lever
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
8 ENGLISH
1
3
2
on the
on the locking
2