Makita MU02 Instruction Manual page 7

To install the base frame, fit the protrusion of base
frame near the change lever into the hole for the
sheared grass height setting. With the base frame so
fitted, pull the lower part of base frame and fit the other
part of the base frame in the groove in the tool.
Installing or removing grass shear
blades
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before installing or
removing shear blades. Failure to switch off and
remove the battery cartridge from the tool may
result in serious injury from accidental start-up.
• When replacing the shear blade, always wear
gloves without removing blade cover so that
hands and face does not directly contact the
blade. Failure to do so may cause personal injury.
NOTE:
• Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
• For specific way of removing and installing
shear blades refer to the reverse of a package
for accessory shear blades.
1
► 1. Blade cover
Remove the base frame and place the tool upside
down.
CAUTION:
• Before placing the tool upside down, be sure to
remove the base frame.
1
4
► 1. Locking lever 2. Undercover 3. Press 4. Turn
3
2
7 ENGLISH
To remove the shear blade, press the locking lever
and with the locking lever pressed turn the undercover
counterclockwise until the symbol
is aligned with the symbol
► 1. Undercover 2. Shear blade 3. Crank
Take out the undercover, shear blade and crank in order
from the tool.
1 2
► 1. Crank 2. Undercover 3. Shear blades
To install the grass shear blade, prepare the crank,
undercover and new grass shear blade.
on the undercover
on the locking lever.
1
2
3
3