Makita MU02 Instruction Manual page 6

Adjusting the shearing height
2
3
► 1. Change lever 2. Protrusion on base frame
3. Base frame
Changing the position of holding the change lever
allows three-stepped setting for sheared grass height
(10 mm, 20 mm, 30 mm).
To change setting, tilt the change lever for the base
frame position and with the change lever tilted move it
up or down along the tool surface until the protrusion
on base frame fits in one of the holes in the tool and
release it.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Installing or removing blade cover
CAUTION:
• Be careful not to contact the shear blade
when installing or removing the blade cover.
Contacting the shear blade may cause personal
injuries.
1
► 1. Shear blades 2. Blade cover 3. Blade frame
1
3
2
6 ENGLISH
Slide the blade cover from the tool's side until the shear
blade completely hides itself and then push in it lightly
towards the tool from the front.
To remove the blade cover, take the above installation
procedure in reverse.
Installing or removing base frame
CAUTION:
• Before installing or removing base frame, be
sure to install the blade cover.
• When installing or removing base frame, take
care that your fingers are not be pinched
between the tool and base frame.
1
► 1. Groove 2. Base frame
To remove the base frame, upset the tool and take it out
of the groove grabbing its bottom.
1
2
3
► 1. Change lever 2. Protrusion on base frame
3. Base frame
2