Makita MU02 Instruction Manual page 12

► 1. Base plate 2. Oval holes that are overlapped
3. Hole in the base plate of shear blades
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center
of these overlapped oval holes.
► 1. Blade cover
Take out the blade cover from the old shear blades and
fit it onto the new ones for easy handling during the
replacement of blades.
1
► 1. Bent part of the base plate of shear blades
Turn the shear blades upside down and install it so that
pin on the tool fit in the hole in the shear blades. Fit the
bent part of the base plate of the shear blades to the
groove in the tool housing. Then make sure that the
base plate of the shear blades is set in place.
1
2
3
1
1
► 1. Screws
Tighten two screws with a coin firmly.
2
► 1. Locking lever 2. Undercover
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
Press the undercover down and with the undercover
pressed down turn the undercover clockwise until the
symbol on the label is aligned with the symbol
the locking lever (the undercover is completely locked.).
12 ENGLISH
1
on the
on the locking
on