Shift + Test Button; Shift + Clean Button - Brother HS-5000 User Manual

English: CS3 User's Guide, Chapter 4
USER'S GUIDE

Shift + Test Button

Shift + Clean Button

4–4
Set the printer to off-line by pushing the Online Button first.
Pressing the Test button while holding down the Shift button starts the test
print. Check the printed test page and if you find any printing problems,
perform the print head cleaning as described below.
Release the two buttons immediately after pressing the Test button and the
DATA LED will start to blink. If it does not, the buttons were held down for too
long and you will need to start the test selection again.
Note
Press the buttons gently. Do not press with too much force or hold the buttons
down for a long time. If you do the operation might now start.
Set the printer to off-line by pushing the Online Button first.
Pressing the Clean button while holding down the Shift button starts head
cleaning. If you see any problems on printouts, clean the print head and try
again.
Release the two buttons immediately after pressing the Test button and the
DATA LED will start to blink. If it does not, the buttons were held down for too
long and you will need to start the test selection again.
Note


Do not open the top cover during the head cleaning operation.


Press the buttons gently. Do not press with too much force or hold the
buttons down for a long time. If you do the operation might now start.