English: CS3 User's Guide, Chapter 4
USER'S GUIDE
Reset and Hex Dump print mode
4–6
The printer has the following Reset and Hex Dump print modes.
1. Keep the FF/Cont button depressed until all four LEDs light. Then, release
the button.
The printer enters the reset/hex dump mode. The Alarm LED blinks to
indicate that the first choice, User Reset, is selected. See the table below.
2. Press the Online button to select another choice.
Every time you press the button, the blinking LED changes to indicate
another choice. See the table below.
3. Press the FF/Cont button to perform the selected choice.
LED
Choice
Alarm
User Reset
Manual
Factory Reset The printer is restored to the factory settings
Data
Hex Dump
print
4. The printer returns to the ready status after printing
Function
The printer is restored to the user default
settings without clearing permanent fonts and
macros.
and permanent fonts and macros are cleared.
The printer can print data as hexadecimal
values, so that you can check data errors and
problems. To exit from this mode, press the
Reset button or turn the printer off.