Brother HS-5000 User Manual page 12

Color printer
Hide thumbs Also See for HS-5000:
Table of Contents

Advertisement

English: CS-5zxx User's Guide, Preliminary (TOC)
USER'S GUIDE
IMPORTANT (For U.K. only)
If the power cord supplied with this printer is not suitable for your electrical outlet, remove the plug from the
mains cord and fit an appropriate three pin plug. If the replacement plug is intended to take a fuse then fit the
same fuse as the original.
If a moulded plug is severed from the power cord then it should be destroyed because a plug with cut wires is
dangerous if plugged into a live socket outlet. Do not leave it where a child might find it.
In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362 with the same rating as the
original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE PROPERLY EARTHED.
The wires in the mains cord are coloured in accordance with the following code:
The colours of the wiring in the power lead of this printer may not correspond with the markings which identify
the terminals in your plug. If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of the plug permits, leave the green and
yellow wire longer than the others so that, in the event that the cord is pulled out of the plug, the green and
yellow wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked
with the letter "E" or by the earth symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which is marked with the letter "N" or
coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or
coloured red or brown.
The outer sheath of the cord must be secured inside the plug. The coloured wires should not hang out of the
plug.
xii
Green and yellow:
Ground
Blue:
Neutral
Brown:
Live

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hs-5300

Table of Contents