Honeywell evohome Applications Manual page 29

4.3.2 Binding the HR80 actuator(s)
f Follow the guided or expert configuration until the
following screen appears.
evotouch controller as close as possible
f Position the
to the HR80 actuator(s).
f Consecutively press the bind buttons (1) on all the
HR80 radiator controllers of the zone.
f Press the BIND button on the
send the signal.
The symbol flashes and the software version number
is displayed for 30 seconds.
During the binding procedure, the
continuously in the display of the HR80 radiator
controller. The display shows:
The HR80 radiator controller is receiving data from
the evotouch controller. This process can take up to
4 minutes.
i
The binding procedure mode remains active at the
HR80 radiator controller for a maximum of 4 minutes.
i
NEXT leads you to the RF communication check.
Application Manual
evotouch controller to
symbol is shown
.
sync
29