Table of Contents
Advertisement
216/261
Bosch Rexroth AG | Electric Drives
Handling and Transport
Transport stators within the
Rexroth-housing
Transport of stators with and with‐
out mounting ring
and Controls
To lift the motor out of the transport crate or to install it into the machine, use
the transport or lifting eye bolts at the motor.
As a minimum, the lifting eye bolts are in accordance with the requirements of
DIN 580. Before each transport, ensure that the lifting eye bolts are screwed
down fully to the stop face and that your selected lifting equipment and lifting
method will not overload the lifting eye bolts.
Please note the DIN 580 standard on transport of motors by means
of the attached lifting eye bolts. Non-observance of the information
in this standard may cause overload of the lifting eye bolts and result
in injury to persons or damage to products.
Stators which were ordered factory-attached with housing, have two ring
screws on the upper face of the housing (see dimension sheet of the stator),
depending on the stator length or size, for transport. Use this ring screws for
lifting and positioning the stators during mounting.
①
Ring screw for transport
Fig.10-3:
Ring screw on example MST450E with housing
①
Ring screw for transport
Fig.10-4:
IndraDyn T transport
Rexroth IndraDyn T | Project Planning Manual
Advertisement
Table of Contents
