Makita TD001G Instruction Manual page 12

Application mode
(Assist type displayed
on panel)
Bolt mode
Bolt mode (1)
Bolt mode (2)
Bolt mode (3)
: The lamp is on.
* When the tool rotates counterclockwise, it rotates same as the 4 (max) mode, 4,400 min
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Quick mode-switching function
What you can do with the quick mode-switching function
The quick mode-switching function saves the time for changing the application mode of the tool. You can switch to
your desired application mode by just pressing the quick mode-switching button. It is helpful when doing a repetitive
work which requires to switch between two application modes alternately.
EXAMPLE If you have a work to use T mode and max impact force, register the max impact force for quick
mode-switching function. Once register it, you can switch to the max impact force from T mode by just one click
of the quick mode-switching button. Also, you can return to T mode by pressing the quick mode-switching button
again.
Even if the tool is in other application mode than T mode, pressing the quick mode-switching button changes to
max impact force. It is convenient for you to register a application mode that you frequently use.
You can choose one of following application modes for quick mode-switching function:
Impact force
• 4 (Max)
• 3 (Hard)
• 2 (Medium)
• 1 (Soft)
Maximum blows
– Clockwise
This mode helps to repeat screwdriving continu-
ously with equal torque. The stroke of the switch
trigger to reach maximum speed will become short
in this mode.
Counterclockwise
This mode helps to prevent a bolt from falling off.
When loosening a bolt with the tool driving in coun-
terclockwise rotation, the tool automatically stops or
slows down after the bolt/nut gets enough loosened.
The stroke of the switch trigger to reach maximum
speed will become short in this mode.
NOTE:
The timing to stop the driving varies depending
on the type of the screw and material to be
driven. Make a test driving before using this
mode.
Clockwise
–
The tool stops automatically as soon as it has
started impact blows.
Counterclockwise
The impact force is 2. The tool stops automatically
as soon as it has stopped impacting.
Clockwise
–
The tool stops automatically approximately 0.3 sec-
ond later from the moment that the tool has started
impact blows.
Counterclockwise
The impact force is 4. The tool stops automatically
as soon as it has stopped impacting.
– Clockwise
The tool stops automatically approximately 1 sec-
ond later from the moment that the tool has started
impact blows.
Counterclockwise
The tool slows down the rotation after it has stopped
impacting.
Feature
12 ENGLISH
Purpose
Clockwise
Preventing over tighten-
ing of bolts.
Counterclockwise
Loosening bolts.
–
–
–
-1
(/min).
.