Table of Contents
Advertisement
Figure 120. SAS/SATA rear backplane connectors
1
2
Step 3.
Install the air baffle into the rear hot-swap drive cage as shown.
Figure 121. Air baffle installation
After installing the rear backplane:
1. Reinstall the drives or drive fillers into the rear hot-swap drive cage. See "Install a hot-swap drive" on
page 112.
2. Complete the parts replacement. See "Complete the parts replacement" on page 203.
SAS/SATA signal connector
Power connector
Chapter 3
.
Hardware replacement procedures
141
Advertisement
Table of Contents
