Table of Contents
Advertisement
Remove the rear backplane
Use this information to remove the rear backplane.
"Read the
installation
Guidelines" on
page 79
Before removing the rear backplane:
1. Remove the top cover. See "Remove the top cover" on page 89.
2. Remove the drives or drive fillers installed in the rear hot-swap drive cage. See "Remove a hot-swap
drive" on page 111 and "Install a hot-swap drive" on page 112.
To remove the rear backplane, complete the following steps:
Step 1.
Gently press and hold the tab on the rear hot-swap drive cage as shown and remove the air baffle
from the rear hot-swap drive cage.
Figure 116. Air baffle removal
Step 2.
Disconnect the cables from the rear backplane.
Step 3.
Carefully lift the rear backplane out of the rear hot-swap drive cage.
Note: There are two types of rear backplanes. The rear backplane you want to install might be
different from the following illustration, but the installation method is the same.
ThinkSystem SR635 Maintenance Manual
138
"Power off
the server for
this task" on
page 11
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 82
Advertisement
Table of Contents
