Breville AirRounder Connect Instruction Book page 5

Allow the purifier fan heater
to cool down before cleaning
or storing.
• Do not operate the purifier
fan heater on a sink or
drain board.
• To avoid an electrical
overload, it is recommended
that no other appliances are
plugged into the same circuit
as your purifier fan heater
when it is in use.
• Do not move the purifier fan
heater when it is switched on.
• Do not use outdoors. This
purifier fan heater is not
intended for commercial use
such as construction sites.
• Use this purifier fan heater
only as described in this
instruction manual. Any
other use not recommended
by the manufacturer may
cause fire, electric shock or
injury and void all warranties.
• Regularly inspect the supply
cord, plug, control settings, air
inlets and outlets and main
housing for any damage.
If found damaged in any
way, immediately cease use
of the purifier fan heater
and return to Breville or an
authorized service agent for
inspection or repair.
• Do not unplug the purifier
fan heater by pulling on the
power cord. Always unplug
using the power plug.
• To disconnect the purifier
fan heater, switch the heater
to OFF, then switch off at the
power outlet and remove the
plug from the power outlet.
Allow the purifier fan heater
to cool down before cleaning
and storing.
• Keep the purifier fan heater
and filter clean. Follow
the cleaning instructions
provided in this book.
• To prevent a possible fire
or heat damage in heating
mode, do not operate the unit
remotely using the Breville
Home Connect™ app when
the unit is unattended.
IMPORTANT
SAFEGUARDS FOR
ALL ELECTRICAL
APPLIANCES
• Fully unwind the power cord
before use.
• Connect only to a 230V or
240V power outlet.
• Do not let the power cord
hang over the edge of a bench
or table, touch hot surfaces or
become knotted.
5