Breville AirRounder Connect Instruction Book page 13

2. To cancel a cooling setting, press the
button to stop operation. If the operation is
stopped, the unit will enter standby mode
and the LED display screen will be dimmed
and display the ambient room temperature.
Heating + Purifying Mode
Your purifier fan heater has 2 heat settings
LOW and HIGH and allows you to set
your desired temperature with the default
temperature setting at 25°C.
1. To choose between these heat settings,
press the button found on the control
panel or button found on the remote
control repeatedly, until the desired setting
illuminates on the LED display screen.
2. To cancel a heat setting, press the
button to stop operation. If the operation is
stopped, the unit will enter standby mode
and the LED display screen will illuminate
'OFF' whilst the unit is cooling down.
WARNING
To avoid overheating, do not cover the heater.
Set Temp
Take control of your room temperature.
Everyone's comfort levels are different, so you
can set your own preferred temperature or even
heat the room before you go to bed.
1. To set the desired temperature, press and
hold the button found on the control
panel or press and hold for 3 seconds the
button found on the remote-control.
2. To increase the temperature press
button repeatedly on the control panel or
button repeatedly on the remote control.
3. To decrease the temperature press
button repeatedly on the control panel or
on the remote control.
4. Once the temperature has been set, the
LED display screen will illuminate the
room ambient temperature. The purifier
fan heater will maintain the room ambient
temperature to the temperature setting
automatically.
NOTE
Choose the heat setting to determine to
determine how quickly purifier fan heater will
maintain the set temperature setting.
NOTE
When the purifier fan heater is turned on from
standby, the memory function will start heating
based on the previously set temperature and
heating setting.
NOTE
When operating the purifier fan heater
remotely in heat mode, the purifier fan
heater will automatically switch off after 7hrs
by default.
NOTE
The purifier fan heater will stop heating and
purifying when the ambient temperature is
greater than the set temperature (e.g. >25˚C).
Ambient temperature will flash and
oscillation will stop.
The unit will start heating and purifying again
when the ambient temperature is less than the
set temperature (e.g. ambient temperature <
set temperature 25˚C). Ambient temperature
will stop flashing and oscillation will resume
at the same angle as previously set, only if the
oscillation button is touched on the control
panel or pressed on the remote control.
13