Landing; Crosswind Landing - Honda HondaJet HA-420 Pilots Operating Manual

HA-420
POM
Extend landing gear no later than abeam the point of intended landing.
Extend flaps to landing during the final turn, and maintain minimum 130
knots until established on final.
Complete the Before Landing checklist.
Use the flight path marker and SV runway symbol to verify the aircraft is
on a 3° flight path.

LANDING

See the AFM for performance landing procedures. Crew must use AFM
procedures to meet charted performance. Excess airspeed, tailwind, and
runway downslope will increase the runway required to land.
NOTE Establish directional control using rudder, and then apply
brakes symmetrically during the initial part of the landing
rollout.
NORMAL LANDING
At 50 ft, rapidly reduce thrust to IDLE and touchdown with minimal
flare. Lower the nose to the runway and apply maximum braking.
Deploy the speedbrake (if installed) and maintain maximum braking
until the aircraft has stopped. If minimum stopping distance is not
required, a normal flare can be performed and braking applied as
required by runway available and conditions.

CROSSWIND LANDING

See the AFM for further guidance.
October 30, 2016
Honda Aircraft Company
HJ1-29000-005-001
FOR TRAINING PURPOSES ONLY
OPERATING PROCEDURES
AND TECHNIQUES
3-36