Performing A Full Recovery Of Windows Nt Or Windows 2000 - HP x4000 Technical Reference Manual

Performing a Full Recovery of Windows NT or
Windows 2000
Depending on the hardware configuration, a full system recovery takes
30 minutes to 2 hours.
CAUTION Remember, this procedure erases everything from the hard drive
(primary partition if defined). Make sure you have backed up all data
files and software applications.
1. Shut down the operating system and turn off your Workstation.
2. Unplug the Workstation from the power source.
3. If any non-standard components were added after you received the
4. Plug the Workstation into the power source.
5. Insert the HP Workstation Recovery CD-ROM containing your
6. Press the
7. Follow the on-screen instructions.
8. Several reboots are carried out. This is normal. Do not interrupt the
9. Remove the HP Workstation Recovery CD-ROM from the CD-ROM
10. The operating system and drivers are installed.
Chapter 11
This manual downloaded from http://www.manualowl.com
Recovering or Reconfiguring Windows 2000 or Windows NT
Workstation, you must restore it to its original factory configuration
(remove the components).
operating system, either Windows 2000 or Windows NT, into the
CD-ROM drive and start the Workstation.
key and select the CD-ROM to boot first. The computer
F12
boots from the CD-ROM and displays a DOS-style menu.
process. Wait until a message indicates the operation has been
successfully completed.
drive.
Troubleshooting
229