Hardware Management (Monitoring and Reporting)
Hardware Monitoring
Hardware Monitoring
Built-in Self Test (BIST)
Zircon Lite does a BIST after resetting and displays the result on the
Diag LEDs (see "Understanding the Diag LEDs" on page 212) if an error
occurs. The following items are checked:
• Accessibility of SEL device
• Accessibility of FRU device
• Accessibility of SDR Repository (read only)
• Viability of Hardware Management Controller (HMC) firmware
• HMC hardware problem (general HMC failure)
Sensor Scan
Voltages, temperatures, fan tachometers, processor-related items, and
chassis intrusion are scanned
Voltages
Pin 10 of Winbond W83782D is be used as a 2.5 V reference. This voltage
is used to calibrate all of the voltage readings in Table 5-1
Table 5-1
Voltage Scan
Sensor
Sensor
Signal
#
ID
20h
+12VIO
+12VIO 10.7V
21h
+3.3VSB 3.3VSB 3.05V
22h
+2.5V
2.5V
72
This manual downloaded from http://www.manualowl.com
(firmware corrupt)
Approx.
Mid
Lower
Limit
12V
3.3V
2.3V
2.5V
.
Approx.
Zircon
Winbond
Upper
Pin
Pin
Limit
13.2V
9
-
3.55V
35
2.7V
7
-
.
Description
12V Supply for
non-VRM
3.3V Standby
2.5V RDRAM
Supply
Chapter 5