Installing or Replacing Parts and Accessories
Floppy Disk Drive
Floppy Disk Drive
Removing the Floppy Disk Drive
1. Turn off the display and shut down the Workstation. Disconnect all
2. Remove the Workstation's cover and front bezel (refer to "Cover and
3. Disconnect the power and data cables from the old drive.
4. Remove the drive by pressing the two front rail clips inward and
5. Remove the two guide rails by gently prying them off the drive. These
Figure 10-23
Removing the Floppy Disk Drive
3
180
This manual downloaded from http://www.manualowl.com
power cables and any LAN or telecommunications cables.
Front Bezel" on page 145 for these instructions).
sliding the drive out the front of the chassis.
guide rails are required for the new drive.
4
Chapter 10