Installing A Floppy Disk Drive, Cd-Rom Drive, Zip Drive, Or Tape Drive - HP Brio 80xx Upgrade Manual

Installing a Floppy Disk Drive, CD-ROM Drive, Zip Drive, or Tape Drive

1 Remove the computer's cover (refer to
2 If the future location of the storage device is in one of the small storage device mounting bays (below the 3.5-inch floppy
drive) at the front of the computer, you must pull out the system board from the back of the computer by 6 cm. This
permits access to the mounting chassis for these storage devices.
3 Pull off the front bezel from the computer by 4 cm.
Be careful when pulling off the front bezel. If you pull the bezel off too far, you will pull the indicator lights out of
Caution
their holders.
4 To allow access to the device, remove the relevant shelf cover plate (from the bezel) by popping out the shelf cover
plate from the front bezel of the computer. Store it in a safe place.
"Removing the Cover" on page
Step 3
2 Installing Accessories in Your Computer
23).
Step 4
Inside View
Cover Plate
Front Bezel
Installing Storage Devices
52