Honeywell Z4 G4 Planning, Installation And Service Manual page 33

The second wedge handle assembly included with this kit is not used in the installation of the HP
Z4 G4 workstation.
8. Push the side spacers in until the handle is flush with the front flange of the side mounting brackets.
9. Install the left and right front retaining brackets. Position the stop peg covered with Vinyl cap such
that it is in contact with the front bezel on the left side and the front bezel handle on the right side.
Tighten the hex threaded standoff to lock each stop peg in place.
Next steps
Refer to the section Connecting cables.
- 33 -
Chapter 3 - Installing