Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
IPv6
Go to the IPv6 tab to change IPv6 address of the access point and configure IPv6 addresses
assignment settings.
Figure 68. Configuring the local interface. The IPv6 tab. The Local IPv6 Address section.
Parameter
Mode of local IPv6
address assignment
IPv6 address
Prefix
Local IPv6 Address
Select the needed value from the drop-down list.
•
Static: an IPv6 address and a prefix are specified manually.
•
Prefix delegation: the access point requests a prefix to
configure an IPv6 address from a delegating router. For the
Router and WISP Repeater modes only.
The IPv6 address of the access point in the local subnet. By default,
the following value is specified: fd01::50. The field is available
for editing if the Static value is selected from the Mode of local
IPv6 address assignment drop-down list.
The length of the prefix subnet. By default, the value 64 is
specified. The field is available for editing if the Static value is
selected from the Mode of local IPv6 address assignment
drop-down list.
Page 77 of 175
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
