Table of Contents
Advertisement
DAP-300P Wireless N300 PoE Access Point / Router
User Manual
MAC Filter
On the Advanced / MAC Filter page, you can configure MAC-address-based filtering for
computers of the access point's LAN. This page is also available in the Firewall section if the
Router or WISP Repeater mode was selected in the Initial Configuration Wizard.
Select the needed action from the drop-down list in the Default mode section to configure
filtering for all devices of the access point's network:
•
Allow: Allows access to the access point's network and to the Internet for devices (the value
is specified by default);
•
Deny: Blocks access to the access point's network for devices.
!
You can use the Deny mode only if an active rule which allows access to the device's
network is created on the page.
To create a rule (specify a MAC address of a device for which the specified filtering mode will be
applied), click the ADD button (
Figure 102. The Advanced / MAC Filter page.
).
Figure 103. The window for adding a rule for the MAC filter.
Page 122 of 175
Configuring via Web-based Interface
Advertisement
Table of Contents
