Adjusting Handle Position; Nylon Cutting Head - Makita XRU23 Instruction Manual

2. Set the angle and position of the handle as shown
in the figure, and then tighten the bolt.
► 1. Handle

Adjusting handle position

Loosen the hex socket head bolt on the handle. Move
the handle to a comfortable working position, and then
tighten the bolt.
1
► 1. Hex socket head bolt 2. Handle
Installing the protector
guard illustrated in place. Failure to do so can
cause serious personal injury.
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
1
► 1. Hex socket head bolt 2. Clamp 3. Protector
Installing the cutting tool
to remove or to install the cutting tool.
inserted into the tool head after installing the cutting tool.
NOTE: The type of the cutting tool(s) supplied as the
standard accessory varies depending on the countries.
The cutting tool is not included in some countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.

Nylon cutting head

NOTICE:
cutting head.
1.
2
motor housing to lock the spindle. Rotate the spindle
until the hex wrench is fully inserted.
► 1. Spindle 2. Motor housing 3. Hex wrench
12 ENGLISH
WARNING:
Never use the tool without the
CAUTION:
Take care not to injure yourself on
1
4. Cutter
CAUTION:
Always use the supplied wrenches
CAUTION:
Be sure to remove the hex wrench
Be sure to use genuine Makita nylon
Insert the hex wrench through the hole in the
3
2
3
4
1
2