Clear Data; Installation - GE Feeder Management Relay 750 Instruction Manual

5 SETPOINTS
5. Continue entering characters and spaces until the desired message is displayed. If a character is entered incorrectly,
repeatedly press the
may also press the
6. Press the
MESSAGE
the instructions in the section on adding default messages.
PATH: SETPOINTS S1 RELAY SETUP

CLEAR DATA

[ENTER] for more
These setpoints are used to clear specific memory functions after the data has been read by an operator. The
setpoint clears all accumulated power consumption data and updates the
ENERGY USE
The setpoint clears all maximum demand data values and updates the
CLEAR MAX DMND
The event recorder saves the most recent 128 events, automatically overwriting the oldest event. The
setpoint clears all recorded event data and updates the
RECORDER
PATH: SETPOINTS S1 RELAY SETUP

INSTALLATION

[ENTER] for more
The
Relay Not Ready
is set to "Ready". This warns against the installation of a relay whose setpoints have not been entered
OPERATION
for the required application. This setpoint is defaulted to "Not Ready" when the relay leaves the factory.
WARNING
These setpoints should be used on a new installation or after new equipment has been installed.
The
RESET TRIP COUNTER DATA
date. The
RESET RESET ARCING CURRENT
date.
LAST RESET
The
RESET AR COUNT DATA
date. The
RESET AR RATE DATA
date. These two setpoints are applicable to the 760 only.
RESET
GE Multilin
Courtesy of NationalSwitchgear.com
key until the cursor returns to the position of the error and enter the correct character. You
ENTER
and keys to restart the editing process.
ESCAPE ENTER
or key when editing is complete. To select this message as a default message, follow
MESSAGE
CLEAR DATA
ð
CLEAR ENERGY USE
ENTER
ESCAPE
DATA? No
CLEAR MAX DMND
ESCAPE
MESSAGE DATA? No
CLEAR EVENT RECORDER
ESCAPE
MESSAGE DATA: No
INSTALLATION
ð
760 OPERATION:
ENTER
ESCAPE Not Ready
RESET TRIP COUNTER
ESCAPE
MESSAGE DATA? No
RESET ARCING CURRENT
ESCAPE
MESSAGE DATA? No
RESET AR COUNT
ESCAPE
MESSAGE DATA? No
RESET AR RATE
ESCAPE
MESSAGE DATA? No
self-test warning message will be displayed until
setpoint clears all accumulated trip counter values and updates the
setpoint clears all arcing current data values and updates the
setpoint clears the autoreclose shot count value and updates the
setpoint clears the autoreclose shot rate value and updates the
750/760 Feeder Management Relay
Range: Yes, No
Range: Yes, No
Range: Yes, No
ENERGY USE DATA LAST RESET
DMND DATA LAST RESET
EVENT RECORDER LAST RESET
Range: Ready, Not Ready
Setpoint reads 750 OPERATION
Range: Yes, No
Range: Yes, No
Range: Yes, No
Message is only seen in 760 relays.
Range: Yes, No
Message is only seen in 760 relays.
S1 RELAY SETUP
AR SHOT COUNT LAST RESET
5.2 S1 RELAY SETUP
5.2.10 CLEAR DATA
CLEAR
date.
date.
CLEAR EVENT
date.
5
5.2.11 INSTALLATION
for 750 relays
INSTALLATION 760
TRIP COUNTERS LAST
ARCING CURRENT
ARCING CURRENT LAST
5-15