Insert A Microsd Card; Equipment Required; Installation Procedure - Honeywell Thor VM3A User Manual

Defroster Setting
Temperature
Manual/Automatic
Defroster On/Off

Insert a microSD Card

You can use a microSD card to increase file storage capacity or to install software.
Honeywell recommends the use of Single Level Cell (SLC) industrial grade SD or
SDHC memory cards with the computer for maximum performance and durability.
Note: Format the memory card before initial use.

Equipment Required

The following equipment is user-supplied:
•
•
•

Installation Procedure

1. For convenience, the computer can be removed from the dock, though it is not
2. Press and hold the Power button until the options menu appears. Tap Power
3. If the computer was removed from the dock, place the computer face down on a
4. Using a #2 Phillips bit loosen the M3 screws and then remove the access panel
Thor VM3A Vehicle-Mounted Computer
Torque tool capable of measuring inch pounds
microSD card up to 512 GB
#2 Phillips screwdriver bit
necessary. If the computer remains in the dock, disconnect the power cable
from the dock.
Off.
stable surface.
with the SD label. This panel is on the top when the computer is face down.
Description
Shows detected LCD window temperature
Tap the button to switch between Automatic mode or Manual
mode. To learn more about the modes, see
Works on page 21 and Manual mode
Tap the button to switch between On and Off.
How Automatic Mode
on page 22.
23