RIDGID MOB16000 Owner's Manual page 6

SP7012 Ridgid MOB16000 ESF.qxp_SP7012 12/20/16 3:33 PM Page 6
Drum/Base assembly (continued)
2. Slide the open end of the axle through
the hole in the side of the power base
until it stops. Install the axle retainer
over the axle with the two screws
provided.
3. Repeat Step 2 for the other rear
wheel.
4. Using a rubber mallet or hammer,
gently tap the wheel caps onto each
wheel center until the wheel caps are
firmly seated onto each wheel. This is
required on both sides.
Screw
(2 each)
Axle
Retainer
Power Base
Wheel Caps (2)
6
Screw (2 each)
Axle Retainer (2)
Wheels (2)