RIDGID MOB16000 Owner's Manual page 14

SP7012 Ridgid MOB16000 ESF.qxp_SP7012 12/20/16 3:33 PM Page 14
operation (continued)
moving the Wet/Dry vac
Should it become necessary to pick the
Vac up to move it, the lift handle on the
top of the lid is used to lift.
To maneuver the Vac, the metal handle
in the rear of the unit should be used.
Blowing feature
Your Vac features a blowing port. It can
blow sawdust and other debris. Follow
the steps below to use your Vac as a
blower.
1. Locate blowing port of your Vac.
2. Insert the locking end of the "Dual-
Flex™ Locking" Hose into the blowing
port of the Vac. The hose should snap
into place. To remove the hose from
the Vac, press the release button in
the hose assembly and pull the hose
out of the Vac blowing port inlet.
3. (Optional) Attach extension wand to
opposite end of hose, then place the
car nozzle on the wand.
4. Turn Vac on and you are ready to use
your Vac as a blower.
Blowing
Port
Dual-Flex
Locking Hose
(Optional)
Accessories
WarninG: always wear safety
eyewear complying with ansi Z87.1
(or in canada, csa Z94.3) before
using as a blower.
WarninG: to reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
caution: Wear a dust mask if
blowing creates dust which might
be inhaled.
caution: to reduce the risk of
hearing damage, wear ear protectors
when using the vac/Blower for
extended time or in a noisy area.
WarninG: Do not leave vacuum
plugged in when not in use.
note: When used as a vacuum, the
muffler/diffuser should be installed into
the blower port as shown. Use of the the
muffler/diffuser will help disperse the
exhaust air stream.
Release
Button
Blowing
Port
14
Diffuser
Release
Button