Drum/Caddy Assembly - RIDGID WD1855AU0 Owner's Manual

Drum/Caddy Assembly

If any parts are missing or damaged
contact Customer Service.
Do not assemble until you have all
the parts.
1. Insert caddy left and caddy right into
the bottom of drum as shown. Light
taps with a mallet or hammer may be
needed to fully seat both caddies.
2. Install (4) screws into matching holes
on both right and left side of caddy,
securing them to the bottom of the
drum. Tighten screws until just snug.
Do not over tighten as this may tend to
deform the caddies.
3. Installing Cap Nut
a. Place cap nut on end of axle.
b. Tap gently with hammer until
fully seated.
c. Place wheel on the axle with smooth
portion of wheel facing outward.
Drain
Screws (4)
Rear Caster
Foot
Caddy Left
Open
End
Cap
Nut
NOTE: Smooth side of the
wheel to the outside.
6 6
Caddy
Right
Caddy
Left
Drain
Front
Caster
Foot
Drain
Caddy
Right
Axle
w/Wheel