Drum/Caddy Assembly - RIDGID WD1851 Operator's Manual

SP6673-1 ES 0108.qxd 1/24/08
Drum/Caddy Assembly (continued)
3. Installing Cap Nut
a. Place cap nut on end of axle.
b. Tap gently with hammer until fully
seated.
c. Place wheel on the axle with smooth
portion of wheel facing outward.
4. Slide open end of axle through caddy
left making sure the leg slot lines up
with the cradle hole. Slide all the way
through the caddy right. Light taps with
a mallet may be required to fully insert
axle.
5. Install second wheel onto axle with
smooth portion of wheel facing
outward.
6. Install the second cap nut. Tap gently
until cap nut is firmly seated
7. Using a rubber mallet or hammer,
gently tap the wheel cap onto the right
wheel until the wheel cap is firmly
seated onto the wheel. This is required
on both left and right sides.
8. Insert the caster stem into the socket
of the caster foot as shown. (Front
caster only).
9. Push on the caster until the ball on the
caster stem is inserted all the way into
the socket. You will be able to hear the
ball snap into the socket and the caster
will swivel easily when positioning is
correct.
1:52 PM Page 7
Caddy Left
Open
End
Cap
Nut
Wheel
Cap
Socket
7
Drain
Caddy
Right
Axle
w/Wheel
NOTE: Smooth side of the
wheel to the outside.
Mallet
Caster Stem
Caster Ball