Maintenance; Removal And Installation Of The Qwik Lock Filter - RIDGID WD1855AU0 Owner's Manual

60 litre professional wet/dry vac
Table of Contents

Advertisement

Available languages

Available languages

Maintenance

Filter
WARNING: To reduce the risk
of injury from accidental starting,
unplug the power cord before
changing or cleaning the filter.
WD1855AU0 Professional Wet/Dry Vac
is supplied with RIDGID's best Qwik
Lock™ Fine Dust Filter. Replacement
Qwik Lock™ Fine Dust Filters are
available where you purchased your
Vac. Ask for the RIDGID Qwik Lock™
Fine Dust Filter VF5000.
NOTE: The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for wet or dry pick-up. Handle the filter
carefully when removing to clean or when
installing it. Creases in the filter pleats
may occur due to installation but will not
affect the performance of the filter.
Removal and Installation
of the Qwik Lock™ Filter
Filter Removal:
1. Hold the filter tabs of the Qwik Lock™
filter in each hand.
2. With one thumb on the Qwik Lock™
stud, which protrudes through the
integrated filter plate, lift up the filter
tabs while pushing down on the stud.
3. This action will cause the filter to
release from the filter cage. Slide the
filter off cage.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pickup.
Filter Installation:
1. Carefully slide the Qwik Lock™ filter
over the filter cage and press down on
the outside edge of the filter until the
rubber gasket on the bottom of the filter
seats securely around the base of the
filter cage and against the lid.
2. Align the small centre hole in the top
of the filter over the Qwik Lock™ stud
on the filter cage. Press firmly on top of
the filter near the stud to allow the filter
to snap over the ball on the end of the
stud. The filter is now attached.
NOTE: Failure to properly seat the bottom
gasket could result in debris by-passing
the filter.
WARNING: Do not operate without
a filter cage and float, as they prevent
liquid from entering the impeller and
damaging the motor.
Integrated Filter
Plate with Centre
Hole
Filter
Tabs (2)
Filter
Cage
Lid
13
13
PUSH
DOWN
PULL
UP
Rubber
Gasket at
Bottom of
Filter
(cutaway
view)
Qwik
Lock™
Stud

Advertisement

Table of Contents
loading

Table of Contents