RIDGID WD1855AU0 Owner's Manual page 7

Drum/Caddy Assembly (continued)
4. Slide open end of axle through caddy
left making sure the leg slot lines up
with the cradle hole. Slide all the way
through the caddy right. Light taps with
a mallet may be required to fully
insert axle.
5. Install second wheel onto axle with
smooth portion of wheel facing outward.
6. Install the second cap nut. Tap gently
until cap nut is firmly seated
7. Using a rubber mallet or hammer,
gently tap the wheel cap onto the right
wheel until the wheel cap is firmly
seated onto the wheel. This is required
on both left and right sides.
8. Insert the caster stem into the socket
of the caster foot as shown. (Front
caster only).
9. Push on the caster until the ball on
the caster stem is inserted all the
way into the socket. You will be able
to hear the ball snap into the socket
and the caster will swivel easily when
positioning is correct.
Installing Handle
Press and hold release buttons while
installing handle into handle receptacles
in drum (See illustration).
NOTE: An audible snap of release
buttons indicates successful engagement
of handle.
Removing Handle
Press and hold release buttons as shown.
While firmly pushing in release buttons,
pull handle upwards to remove
(see illustration).
Wheel
Cap
Caster Stem
Caster Ball
Socket
7
Mallet
Release
Buttons
Handle
Receptacles