Restore Default Settings With Printset; Clean The Printhead - Honeywell PC42t User Manual

7 Click Restore.
8 Click Yes to continue. The printer restarts and the settings you

Restore Default Settings with PrintSet

If you have PrintSet installed on your PC, you can use it to restore the
default settings on your printer.
•

Clean the Printhead

Cleaning the printhead on a regular basis is important for the life of the
printhead and for the best print quality. You should clean the printhead
each time you replace the media. Follow this procedure to clean the
printhead using the cleaning card. If you need to clean additional residue
from the platen roller or tear bar, use a cotton swab moistened with
isopropyl alcohol.
Caution: Never use hard or sharp tools to peel away stuck labels or
other material. The printhead is delicate and can easily be
damaged.
1 Turn the printer off and disconnect the printer from power.
2 Open the printer, open the print mechanism, and remove the media
3 Insert most of the cleaning card under the printhead, and then lower
4 Pull out the cleaning card and raise the printhead.
5 Wait for approximately 30 seconds to allow the cleaning fluid to
6 Print a test label to check for print quality. For help, see "Print a Test
7 Repeat Steps 3 through 5 if necessary.
8 If necessary, clean residue from the platen roller or tear bar with a
9 Once the parts are dry, replace the media (and ribbon) in the printer.
10 Close the printer, reconnect power, and turn on the printer.
PC42t Desktop Printer User Guide
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
Chapter 3 — Troubleshoot and Maintain the Printer
selected are restored to default values.
Use the Factory Default Wizard.
and ribbon (if installed).
the print mechanism.
dissolve the residue.
Label When the Printer is Ready to Print" on page 20.
cotton swab moistened with isopropyl alcohol.
V10 CONSUMIBLES S.L.
35